Service & Maintenance Question
I was having trouble getting my 325L trimmer started and...Answeredescalated
Service & Maintenance Question posted August 20, 2011 by Steve Keane, last edited February 10, 2012
240 Views, 1 Comment
Question:
I was having trouble getting my 325L trimmer started and keeping it running. After examining it I found both 537 04 24-01 lines were broke. I replaced them both with general fuel line. Now it starts and runs for awhile, 3-4 minutes, while I work with it but then it slows down and stops. I have trouble getting it going again and then get the same scenario. The fuel line I used appeared to have a smaller I.D. Is it possible the line is not allowing enough fuel to get through or should I be looking at something else? Steve Keane
Best Answer
Answer
Thank you for contacting the AnswerARMY.
It is possible that the lines are to small, however I suspect that you have other problems more likely contaminants introduced when the lines were broken.
Because this is emissions related, you should have your local authorized Husqvarna service center look at the machine. I suspect contaminants in the carburetor, and will need to be professionally cleaned.
Thank you for contacting the AnswerARMY.
It is possible that the lines are to small, however I suspect that you have other problems more likely contaminants introduced when the lines were broken.
Because this is emissions related, you should have your local authorized Husqvarna service center look at the machine. I suspect contaminants in the carburetor, and will need to be professionally cleaned.