Question:
I am trying to assembly my blower/vac, Husqvarna Model 125BV, X Series. The Tube Clamp Bolt (part #17) appears to be too short. Another problem seems to be that one end of the hole where the Tube Clamp Bolt goes through is cut out for a hex shape. However, neither end of the Tube Clamp Bolt is hex-shaped. The manual contains no real directions, just a diagram. Can you advise? Is it possible that we were sent the wrong Tube Clamp Bolt? Thank you.
Robert,
Thank you for contacting Husqvarna. The tube clamp nut #18 should go in the hex cutout of the tube clamp, then
the tube should be pushed all the way in the clamp. The tube clamp screw should then reach the nut.
I hope this helps to answer your question.