General Product Question
Hello Answer ARMY!
I have a 128 CD (curved shaft)...escalated
General Product Question posted June 23, 2014 by Greg Himonidis
661 Views, 1 Comment
Question:
Hello Answer ARMY!
I have a 128 CD (curved shaft) that I am going replace the bump feed head on. However, I have cannot seem to get the head off the trimmer.
I remove the string and the cap and I have a giant spring staring at me. How do I step the head from spinning so I can take this off and put on a better head.
Thanks,
Greg H
I have a 128 CD (curved shaft) that I am going replace the bump feed head on. However, I have cannot seem to get the head off the trimmer.
I remove the string and the cap and I have a giant spring staring at me. How do I step the head from spinning so I can take this off and put on a better head.
Thanks,
Greg H
Answer
Instructions on page 14 of the following manual. Note it show installing the head so turn the opposite to remove.
/images/ddoc/HUSO/HUSO2012_NAenNAfrNAes/HUSO2012_NAenNAfrNAes__1153743-27.pdf
Be the first to rate this
|