Question:
Hello, i bought a Husqvarna K760 demo saw. I live at 5300' elevation, and use this saw between 5000' and 11,000. Upon brand new purchase of saw and husky oil, brought it down to the local dealer asking how to achieve better performance at higher elevation. we3 proceded to start saw for the first time, warmed up, and adjusted the low, then went to adjust the high to no avail, tried turning both cw and ccw all the way and saw continued to run wide open. We then cut into a scrap pile of steel and saw immedietly bogged down, basically no power under load, although still cutting, just terribly slow. Why cant we adjust the highs? Do you need the serial number? The mix was perfect and well shaken up. Thank you, Anthony
Service & Maintenance Question last edited February 10, 2012 by Anthony Burgos in Husqvarna: Ask & Answer > Power Cutters publicQuestion:Hello, i bought a Husqvarna K760 demo saw. I live at 5300' elevation, and use this saw between 5000' and 11,000. Upon brand new purchase of saw and husky oil, brought it down to the local dealer asking how to achieve better performance at higher elevation. we3 proceded to start saw for the first time, warmed up, and adjusted the low, then went to adjust the high to no avail, tried turning both cw and ccw all the way and saw continued to run wide open. We then cut into a scrap pile of steel and saw immedietly bogged down, basically no power under load, although still cutting, just terribly slow. Why cant we adjust the highs? Do you need the serial number? The mix was perfect and well shaken up. Thank you, Anthony