General Product Question
I have a new DRT 900H tiller. The manual says to reset the...
General Product Question posted March 21, 2018 by William Miller, last edited March 21, 2018
28 Views
Question:
I have a new DRT 900H tiller. The manual says to reset the wheel clevis pin and move the wheels further apart for tilling or cultivating. Is this right do the wheels need to be close together for transport and moved apart to cultivate or till??
Details:
ADJUST WHEELS FOR CULTIVATING (See Figs. 17 and 18) • Place blocks under right hand side of tiller and remove hairpin clip and clevis pin from right hand wheel. • Move wheel outward approximately 1 inch until hole in inner wheel hub lines up with inner hole in axle. • Replace clevis pin and hairpin clip on inside of wheel and remove blocks. • Repeat preceding steps on left hand side. NOTE: In extremely rough conditions and while cultivating, the wheels should be moved outward on the axle for increased stability.
