Service & Maintenance Question
I was servicing our string trimmer and when putting grease...Answered
Service & Maintenance Question posted June 9, 2010 by jimnlinda, last edited February 10, 2012 by Husqvarna
, tagged 128LD
, tagged 128LD 2086 Views, 3 Comments
Question:
I was servicing our string trimmer and when putting grease in the angled beveled gear housing, I was not sure as to how much grease it should contain. Not enough or too much will cause problems. What do you folks recommend.
thanks for your time.
model 128LD
jim
thanks for your time.
model 128LD
jim
Photo:
Average Rating:
100% (+2/-0)|
-
Best Answer
Answer
- posted July 14, 2016 by Douglas Huff
- Permalink
yes, so much is stated in the manual
just how does one determine when the bevel gear is 3/4 full?
- posted June 10, 2010 by Brandon M.
- Permalink
Awesome photo, Jim!
The grease in the bevel gear does not normally need to be changed except if repairs are carried out. The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three quarters (3/4) full with grease. Be sure to use Husqvarna special grease from your local Service Dealer.
Thank you again for the photo and contacting Answer Army.
- posted June 10, 2010 by Brandon M.
Awesome photo, Jim!
The grease in the bevel gear does not normally need to be changed except if repairs are carried out. The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three quarters (3/4) full with grease. Be sure to use Husqvarna special grease from your local Service Dealer.
Thank you again for the photo and contacting Answer Army.