This is a public Forum  public

Service & Maintenance Question

    Sheila Cloudcroft
    I have a Husqvarna HU625HWT. I had to replace the carrier...
    Service & Maintenance Question posted August 14, 2017 by Sheila Cloudcroft, last edited August 14, 2017 
    258 Views, 1 Comment
    Question:
    I have a Husqvarna HU625HWT. I had to replace the carrier plate & mow ball assembly as they were damaged during use. String couldn't be clipped on the carrier plate b/c the clips were broken off. The mow ball assembly was cracked. I began reassembly but am confused. The locking plate spring had become rusted & stretched so I bought a new one. When removing the old parts the locking plate wasn't doing anything. The locking plate & retaining ring that I took out during disassembly & the new spring aren't currently attached because I have no idea of the right configuration for them. Not sure what they do. I believe the spring on one side attaches to the locking plate but where else does it attach? What does the locking plate do, just sit on top of the carrier plate, or? The assembly diagrams are not specific regarding connections/placement of the parts. Deeply appreciate any help or links to helpful material that can be offered.

    WASN'T SURE WHERE TO POST, ALSO HERE -> POST LINK: http://answerarmy.com/posts/b0bce075b6
    Details:

    IMAGES FROM: http://www.ereplacementparts.com/husqvarna-hu625hwt-20130396173000400-trimmer-parts-c-114486_117795_260296.html  - reposted here for informational purposes only.

    Husqvarna HU625HWT Parts Diagram

          A-31 

     
    A-32

    A-32 Spring (PN 532173973) 

        A-33 A-33 

        A-34 

        A-35 

     

    PARTS INVOLVED:

    Retaining Ring P/N: 532174581

    Spring P/N: 532173973

    Locking Plate P/N: 532172519

    Carrier Plate P/N: 532180338

    Mow Ball Assy P/N: 532182217

     
     
     
    • Be the first to rate this

      |

    • Bookmark and Share

    Answer

     

    • Eugene Rounds

      If remember correctly the snap ring goes on the spindle shaft next to the bearing. The spring fits into a hole in inner carrier surface and the locking plate pushes against spring so the carrier can slid on and set at the height you desire. Remember as you slide on the carrier onto the spindle shaft that spindle notches goes toward the side with the spring so the spring can push the locking plate into one of the notches.

      • Average Rating: Average Rating100% (+1/-0)

        |