Hi, I bought an old 25r Trimmer from a local auction and had it tuned up by our local service center. They started it there without a problem but now I can't get it started. I've tried full choke, half choke, pushing the bulb a few times, pushing it a bunch of times, trigger in, trigger out, nothing seems to work. I'm sure I am doing something wrong but I don't know what. I also can't seem to find the owner's manual anywhere so I don't know what the right steps are. Can anyone out there help?
Hi Scott
Thanks for contacting the AnswerArmy to post your questions.
COLD ENGINE
1. Put the stop switch in position "ON".
2. Press the tickler button (A) while pumping on the
primer pump (B) until fuel comes from the overflow
pipe (C).
NOTE! When pumping with the primer pump the
tickler button must be pressed in not to overrich
the engine. This could make the engine
difficult to start.
3. Put the throttle lever in the start position using the
throttle latch (D) shown in picture.
4. Put the choke lever (E) in its upper position.
5. Hold the saw on the ground in a steady position. Pull the
starter slowly until the starter pawls engage. Then pull
sharply but do not pull it out completely.
6. As soon as the engine starts or ignites, the choke lever
shall be opened, i.e. pressed down.
7. Press the throttle control to full throttle momentarious-
Iy to disengage the throttle latch.
WARM ENGINE
Operate as said under cold engine, but without the
procedure,
Thanks again from the Husqvarna Technical Services Team.
Hi Scott
Thanks for contacting the AnswerArmy to post your questions.
COLD ENGINE
1. Put the stop switch in position "ON".
2. Press the tickler button (A) while pumping on the
primer pump (B) until fuel comes from the overflow
pipe (C).
NOTE! When pumping with the primer pump the
tickler button must be pressed in not to overrich
the engine. This could make the engine
difficult to start.
3. Put the throttle lever in the start position using the
throttle latch (D) shown in picture.
4. Put the choke lever (E) in its upper position.
5. Hold the saw on the ground in a steady position. Pull the
starter slowly until the starter pawls engage. Then pull
sharply but do not pull it out completely.
6. As soon as the engine starts or ignites, the choke lever
shall be opened, i.e. pressed down.
7. Press the throttle control to full throttle momentarious-
Iy to disengage the throttle latch.
WARM ENGINE
Operate as said under cold engine, but without the
procedure,
Thanks again from the Husqvarna Technical Services Team.