Question:
One of my blades on my 54" Z-turn has fell off twice, luckily both times were right after I shut off the blade drive. The first time I figured I must not have tightened properly, but after the second time, I know this not to be true...Additionslly, the hour meter quit working right after purchase but the local Husqavarna repair center says since I did not purchase from them (I bought from AAFES) they will not accept any warranty work from me.
Answer
Need the model number to look up the IPL to see which spindles are used.
Be the first to rate this
|
The model # is RZ5424
Be the first to rate this
|
Sorry for the delay I putting a front axle bearing in Cam Am took a little 2 hrs to do.
Look-up your deck. Take a close look at star on the spindle shaft if it is worn badly which I would suspect after loose blade it will need replacing or you will continue having problems. These are replaceable without removing the whole spindle. Matter it best not to as the the mounting tend to break if you attempt to remove them. You need remove the deck to do this. The Spindle shaft PN is 532187291.
Also also both top and bottom nuts are tighten to 55 ft-lbs.
Be the first to rate this
|