Service & Maintenance Question
Husqvarna 340, I need the proper part number, and/or any...
Service & Maintenance Question posted October 24, 2017 by Victor Malchesky
43 Views, 3 Comments
Question:
Husqvarna 340, I need the proper part number, and/or any superceding numbers, for the drive sprocket/hub assembly and bearing.
My saw info:
Product # 967 01 33-00
Serial # 02 1501447
My saw info:
Product # 967 01 33-00
Serial # 02 1501447
Details:
I ordered a part over the internet. The shipped part is fifty thousandths thicker (face of sprocket to inside lip in hub). When I thread on the clutch assembly everything seems fine until the last half turn. Then the clutch binds against the hub and the hub will no longer spin freely on the output shaft.
The lady at one of the local Husqvarna dealers said her books showed it was no longer made by Husqvarna, but that Poulan had one that would fit.
Evidently I can only post one picture. The picture shows how I took the measurement; steel block, sprocket down, to the inside lip of the hub. The new part measures 0.574 in. and the existing part measures 0.525 in.
Photo:
Answer
What part number did they send?
Be the first to rate this
|
I am needing the part of one sent as I do show that Spur drum is still available just under superseded PN and I need to cross reference the part you received as you may the wrong one.
Be the first to rate this
|
The part I bought from Amazon came out of United Express Distribution. It has a part number of X001DE54NB.
I contacted a local Husqvarna dealer and the lady tracked down what I think is a Poulan part number 578097901. She has ordered it for me and it should be in tomorrow (Thursday) afternoon.
Thank you for your time and attention.
I will post here if this Poulan one fits.
Be the first to rate this
|