This site requires JavaScript to function properly. JavaScript is either disabled or not supported in your browser. Try enabling JavaScript in your browser and then refreshing this page.

Chainsaws

This is a public Forum public

Service & Maintenance Question

I recently purchased a P3314WSA chain saw and the choke...Answeredescalated

Service & Maintenance Question posted August 30, 2011 by Robert Jones, last edited February 10, 2012

639 Views, 2 Comments

Question:

I recently purchased a P3314WSA chain saw and the choke lever snaps back in when I try to pull it out. Any ideas how this can be remedied? I have made sure that the on and off lever is in the on position.

Details:

Be the first to rate this
|

Best Answer

posted August 31, 2011 by Scott W.
Permalink

Thank you for contacting the AnswerARMY.

It is upsetting that you have had this experience.

Please make sure the trigger is not activated, when the choke lever is pulled out, the choke should stay out. If this is not happening please take the unit to your local authorized Poulan service center for evaluation and repair.

Answer

- posted August 31, 2011 by Scott W.
- Permalink
Thank you for contacting the AnswerARMY.

It is upsetting that you have had this experience.

Please make sure the trigger is not activated, when the choke lever is pulled out, the choke should stay out. If this is not happening please take the unit to your local authorized Poulan service center for evaluation and repair.
- Be the first to rate this
  |

- posted October 28, 2011 by Thomas McMahon
- Permalink
I have the same problem. I used the saw once. any updates on another fix or do I need to go to a dealer?

Thanks
- Be the first to rate this
  |