Husqvarna: Ask & Answerpublic

Chainsaws

 
This is a public Forum  public

Parts Question

    Richard Shabenas
    My 3120xp has a 36" bar and runs 3/8" pitch chain....Answeredescalated
    Parts Question posted January 10, 2012 by Richard Shabenas, last edited February 10, 2012 
    527 Views, 2 Comments
    Question:
    My 3120xp has a 36" bar and runs 3/8" pitch chain.

    I want to go to a 36" bar with .404 chain.

    As far as I can figure out, I need a 404-7 rim sprocket, part #22270, a .404 pitch 104 drive link .063 gauge chain, and a .404 pitch 36".063 bar, part #608000063.

    I already have the Husqvarna piston stop tool needed to do the change over.

    I've always wondered how tight to torque the retaining nut, so is there a recommended torque?

    Thanks

    • Be the first to rate this

      |

    • Bookmark and Share

    Best Answer

    Greg P.

    Hi Richard,

    Thanks for contacting Husqvarna to post your question.

    The clutch should be installed at 28 foot pounds or 336 inch pounds of torque.

    I hope this helps answer your question.

    Answer

     

    • Greg P.

      Hi Richard,

      Thanks for contacting Husqvarna to post your question.

      The clutch should be installed at 28 foot pounds or 336 inch pounds of torque.

      I hope this helps answer your question.

      • Be the first to rate this

        |

    • Richard Shabenas

      Hello Greg:

      Thanks for the prompt torque answer.

      Does my conversion parts list seem like it's complete to you?

      　

      • Be the first to rate this

        |