Service & Maintenance Question
I have a 435 chainsaw and the bar will not oil. I have...escalated
Service & Maintenance Question posted January 22, 2012 by Dennis Conner, last edited April 7, 2012
1360 Views, 5 Comments
Question:
I have a 435 chainsaw and the bar will not oil. I have replaced the oil pump and drive gear. If I take the bar off and run the saw, it will pump oil. I have cleaned out the oil hole on the bar. If I put the bar back on it will not oil the chain or even use oil out of the oil tank. What do I need to do to fix this?
Average Rating:
100% (+1/-0)|
-
Answer
What does "escalated" in orange letters mean?
I notice that it is written to the right of the title of this post.
Be the first to rate this
|
I also have this problem. Hope to see an answer soon. I have the 460 Rancher.
Be the first to rate this
|
Be the first to rate this
|
Had a Husqvarna dealer tell me that the Husqvarna bar oil is too thick. He suggested using 30w motor oil. It works well in these saws.
Be the first to rate this
|
I don't understand why someone from the "Answer Army" has not commented on this question.
This was posted 7 months ago, and has been viewed 222 times, but no one from the "Answer Army" has responded.
What does it take to get "the army of outdoor power experts" to respond to this question?
Be the first to rate this
|