Hi John,
If your experiencing a high speed wobble you probably need to look at replacing some parts (ie bearings) in the end of the cutting arm. You should not have any or very minimal radial play in the bearings where you mount the blade on the shaft. Being a demo unit it is very likely that these parts have reached their service limits. It can be dangerous to operate a piece of equipment that has become worn thru use. Please repair or get your cutter into a servicing dealer to have it looked at. Hope this helps.
Regards,
Chip
Hi John,
If your experiencing a high speed wobble you probably need to look at replacing some parts (ie bearings) in the end of the cutting arm. You should not have any or very minimal radial play in the bearings where you mount the blade on the shaft. Being a demo unit it is very likely that these parts have reached their service limits. It can be dangerous to operate a piece of equipment that has become worn thru use. Please repair or get your cutter into a servicing dealer to have it looked at. Hope this helps.
Regards,
Chip