Parts Question
"Adjustment Screw" for Husqvarna 316 Electric...escalated
Parts Question posted June 3, 2013 by Ed Rezny
467 Views, 1 Comment
Question:
"Adjustment Screw" for Husqvarna 316 Electric chainsaw: The "adjustment screw" (as described in the manual's write-up below) on my 316 electric chainsaw snapped recently, but I cannot figure out the number of the part to order. The parts information I've seen online generally lists a number of screws that can be ordered, but not one specifically described below as the adjustment screw. Can you help me determine this? Thanks.
"Seat the guide bar on the adjusting pin and replace the clutch cover. Check that the drive links fit correctly on the drive sprocket and that the chain is in the groove on the bar.
Tighten bar nuts finger tight. Adjust chain tension, using
combination wrench to turn adjustment screw clockwise to
tighten. Tighten adjustment screw until the chain is drawn
snugly against the underside of the bar."
"Seat the guide bar on the adjusting pin and replace the clutch cover. Check that the drive links fit correctly on the drive sprocket and that the chain is in the groove on the bar.
Tighten bar nuts finger tight. Adjust chain tension, using
combination wrench to turn adjustment screw clockwise to
tighten. Tighten adjustment screw until the chain is drawn
snugly against the underside of the bar."
Answer
Ed,
The part number is Husqvarna 508 04 62-03, see attached diagram of your chainsaw.
I hope this helps.
Be the first to rate this
|