This site requires JavaScript to function properly. JavaScript is either disabled or not supported in your browser. Try enabling JavaScript in your browser and then refreshing this page.

String Trimmers

This is a public Forum public

Service & Maintenance Question

I replaced the ignition module on my 125C trimmer and set...escalated

Service & Maintenance Question posted July 26, 2014 by James Huff

164 Views, 3 Comments

Question:

I replaced the ignition module on my 125C trimmer and set the gap between the fly wheel and module at .024", is this the correct gap setting?

Be the first to rate this
|

Answer

- posted July 26, 2014 by Eugene Rounds
- Permalink
- Show/Hide Replies
It should be between .010" and .015" (.3mm - .38mm)
- Average Rating: 100% (+1/-0)
  |
- posted July 26, 2014 by James Huff
  
  Permalink
  Thank you very much for the information. I was a little concerned that .024" was too much. Thanks again!
  
  huffy
  Be the first to rate this
  |
- posted July 26, 2014 by James Huff
  
  Permalink
  I thought I had replied to this answer before but I don't see it listed. Just wanted to thank Eugene Rounds for his help I will re-adjust the clearance to .013".
  Be the first to rate this
  |