Question:
I just purchased a 345FR Brushcutter. The dealer had it waiting for me when I went to pick it up. One of the employees carried it outside and started it while I pulled my truck up to the entrance. He showed me the basics, and shut it off.
When I got home, I read the owners manual, reviewed the components, setup the harness, etc ... and then attempted to unsuccessfully start the 345FR. I triple-checked the instructions to make sure I wasn't missing a step. Nada .. nothing. Pretty frustrating. I paid a pretty penny for this model. My right hand and elbow are sore from the 50+ pulls before I finally gave up.
I own a husq chain saw that has a very similar startup method (decompression valve, choke, primer bulb, etc ...) so I am not a total idiot. This is my 2nd brushcutter, but my first husqy brushcutter.
The fuel was mixed by the dealer, so I assume it is good!
The dealer is 40 min one-way drive ... would appreciate any last troubleshooting steps or advice before I return the brushcutter next Weekend. Thanks!
Answer
Good luck on any repair. A new 555fx with a suspected air leak. Took it to the service center, eyes crossed, been in the service center for six weeks and all they can say is air leak.
Be the first to rate this
|