Service & Maintenance Question
3120xp 2 problems. Leaks when topped off... I have pulled...Answeredescalated
Service & Maintenance Question posted April 17, 2012 by Mike Fisher, last edited April 17, 2012
452 Views, 1 Comment
Question:
3120xp 2 problems. Leaks when topped off... I have pulled tank and noticed tank vent has fuel on outside.. have ordered one from local dealer. how do i pull the old and insert the new? Saw won't start when hot.. can i test the module (part #5039017-01) if so how can i do this?
Thanks, Mike
Thanks, Mike
Best Answer
Answer
Mike,
Thanks for contacting Husqvarna to post your questions.
To pull the tank vent simply knock it out with a long slim screwdriver and when you re-install the new one you may need a drop of super glue to keep it in place. As for the ignition module without the proper equipment you can't test it. Before you go to replace it try removing it and lightly sand where it mounts to make sure its getting a good ground. Depending on how old the machine is the module may be covered under warranty, if it is more than 6 months old then you would be responsible for the labor only the part should be covered.
I hope this helps and thanks again.
Mike,
Thanks for contacting Husqvarna to post your questions.
To pull the tank vent simply knock it out with a long slim screwdriver and when you re-install the new one you may need a drop of super glue to keep it in place. As for the ignition module without the proper equipment you can't test it. Before you go to replace it try removing it and lightly sand where it mounts to make sure its getting a good ground. Depending on how old the machine is the module may be covered under warranty, if it is more than 6 months old then you would be responsible for the labor only the part should be covered.
I hope this helps and thanks again.