Comments
- 1-1 of 1
- posted April 19, 2014 in Husqvarna: Ask & Answer > Chainsaws
- Permalink
On the problem of Husqvarna chain not getting oil. I say 80/20 chance that the oil hole in the bar is stopped up with sawdust. there are two
holes in the bar. Usually for quick fix inspect the holes. The bottom hole is used to tighten chain and if the saw isn't too old this hole
is clean. Just flip the bar so this hole is now on top. When you have time, blow out the holes with compressed air or a pressure washer.
Good sawing,
CQR