ok I have a crt 900 tiller, I just changed the drive belt, it was a 52x1/2. problem is now when I put it in gear it goes without depressing the clutch lever iam stumped?
Just bought a new FT900. The reverse doen't work. I checked the belts and the cable adjustment. They seem to be okay. The manual information for checking forward rotation is very clear. Is the check for reverse rotation the same? If so why doesn't it activate?
I have had the input shaft bearing go out several times. The gear case is full of grease but it doesn't keep that bearing greased. What do I need to do?
My DRT900H says to grease the RH transmission fitting every season. Does this need to be done on the initial season or is it greased at the factory for the first season?
I have a tiller model #700DRT and the wheels won't turn. It doesn't matter what gear I'm in or if the unit is running or not. I had to physically drag it into my garage to store it. Could it be that the belt slipped or is this a bigger problem (like the transmission)?
I has a Husqvarna drt 700, while tilling the wheels became locked, the tines will rotate forward and in reverse, but no matter where I move the transmission lever the wheels remain locked.
My FT900 tiller continually stalls after 15-20 minutes of use. I have taken it into an authorized dealer and they performed the basic troubleshooting as well as replacing the gas, spark plug and air filter. My tiller is only 3 years old.
Any suggestions?
I just purchased as DRT-900. After tilling for about 10 minutes, it began making a rubbing sound when it moves. It is worse in forward or tilling, but also makes the noise when in reverse or rolling in neutral. What should I inspect to find the cause of the problem?