Posts
- 1-5 of 5
Question:Is it normal that my 445 chainsaw leaks a lot of chain oil ?- Question:I purchased a new 445 chainsaw. The "how to" instructions on lubricating the needle bearing on page 28 and the picture (#110) on page 6 is not clear to me. Also, the instructions calls for motor oil, in answer to a customer the reply stated to use grease.
- Question:Is it true that all similar chainsaws are not built the same?For example, Husqvarna 445 purchased at a box store is not the same quality as a 445 purchased at a Husqvarna dealer? The one at a box store has inferior parts?
- Question:Have a 445 18Inch Hus. chain saw, purchased at Lowes in Gadsden, AL. Have had it about one year.
Since day one it would run for anywhere from one to two tanks of fuel then shut down. No matter what you did it would not restart for 30 min to and hour or more. Very fustrating. Otherwise a very good saw.
What is the cure? does it have a thermal cutoff system for over heating? Most of the cutting I do would not seem to overheat a properly working saw. [I am a home owner].
I have tried cleaning the air filter, cleaning the plug, when this happens. No luck. Just have to wait it out.
Thanks
Jack Ward
***.***.xxxx - Question:What is the tourque setting for a guide bar bolt on a 445 chainsaw?
Filter by Type
Filter by Tag
- All
- 235
- 235 e-series
- 240 e-series
- 3120 XP®
- 316 e-series
- 334T
- 338 XP® T
- 339 XP®
- 346 XP®
- 346 XP® E-TECH® TrioBrake™
- 346 XP® G
- 350
- 353G E-TECH®
- 357 XP®
- 357 XP® G
- 359
- 372 XP® W
- 385 XP®
- 385 XP® G
- 385 XP® W
- 390 XP®
- 390 XP® G
- 390 XP® W
- 395 XP®
- 395 XP® G
- 395 XP® W
- 435
- 440 e-series
- 445
- 445 e-series
- 450
- 450 50th Anniversary Edition
- 450 e-series
- 455 e-series Rancher
- 455 Rancher
- 460 Rancher
- 570
- 576 XP®
- 576 XP® AutoTune
- 576 XP® G
- 576 XP® W
- 576 XP® W AutoTune
- T435