I recently bought a weedeater model FL20C,the first time I used it worked fine. The second time,it would run only on full choke. when turned to half or run,it would stall.I am using a premix 40:1 fuel mixture. any help would be appreciated.
The throttle on my 223L trimmer seems to be stuck. When first purchased, the choke would not go into the lowest setting. Now, the throttle will not move at all.
I bought the FX26SCE on February 29, 2012. Followed the instructions and it will not start. I've tried twice on two separate occasions so that any buildup in the carburator may evaporate. The second time was today. It still will not start.
I recently purchased a WeedEater FL20C string trimmer from Northern Tool. The line reel does not rotate unless I pull very hard upward on the bottom shaft. As soon as I release the shaft it stops spinning or rotates very slowly. The two sections mesh together fine and I have tightened them very hard. Is something wrong with the cable meshing with the upper shaft drive? Solutions? Hope you can help. Fred
How do I get a service manual for my weedeater? I have taken it apart, found a broken fuel line which will be repaired, but I can't remember how to put it together again. I could use a picture!
What is being done about the Triggers for the 125L String Trimmers? Part Number: 503-05-98-07 I have a perfectly good $100+ Trimmer that I can not us because a $5.00 part is not available... is something in the mill for a substitute or are we on our own?