This is a public Forum  public

Posts

  • Mark Hagen
    9/28/2011 Purchased expensive POS!!!!!! model 1827EXLT....escalated2
    General Product Question posted February 11, 2013 by Mark Hagen 
    Question:
    9/28/2011 Purchased expensive POS!!!!!! model 1827EXLT. 12/2012, First time I used it very little drive power forward or reverse and only one side propelling and wants to spin in circles. Load up in pickup haul in for waaranty. Find out wrong drive belt from factory and one side clutch spring not even there.
    2/11/2013 After MAJOR snow storm have to get to work! Start machine start blowing snow. Within ten minutes very little if any snow leaving the snow shoot. Is shoot plugged? No! Borrow neighbors twenty year old TORO finished my drive way and go to work. Come home from work investigate my problem with my Husqvarna! Find oil all over front of engine block, pulleys and belts! Four side crank case bolts almost completley out of crank case! I get to haul it in again!!!!!!!!!!!!! Only 4-5 hours on the machine!!!!!!! Any recourse with you people?!?!?!?

    Purchased 9/28/2011
    product # 961930077
    serial # 081811M000097 registered under warranty

    My First and for sure last Husqvarna product ever!!!!


    Warmest Regards, (For sure!)

    Mark Hagen
    West Fargo, ND
  • Brian Porterfield
    Add heated grips? New 27" Snowblower model 12527HVX...escalated
    General Product Question posted February 9, 2014 by Brian Porterfield 
    Question:
    Add heated grips? New 27" Snowblower model 12527HVX with a Briggs & Stratton 250cc Snow Series 1150 engine, purchased from Lowes. It has enough 12v power for the LED Light. Huskvarna doesn't seem to offer heated grips. I want to use 12v heat trace wire to make my own heated grips. How much load will the 12v generating circuit tolerate? Will this void my Briggs engine warranty? I see no 12v data in the manual or on-line. Thanks!
  • steve errington
    Are there any dealers in MN near the twin cities that...Answeredescalated2
    General Product Question posted November 9, 2011 by steve errington 
    Question:
    Are there any dealers in MN near the twin cities that actually STOCK Husqvarna snowthrowers? I'd like to buy one, but want to actually get my hands on one before I but. I have called a bunch from the "dealer locater" and none have any in stock. Please advise.
  • Sherwood Drumheller
    Are wheel weights available for my ST224 snow thrower
    General Product Question posted August 31, 2016 by Sherwood Drumheller 
    Question:
    Are wheel weights available for my ST224 snow thrower
  • Shelby Nickell
    Both questions are about the model 1827EXLT, part #...escalated
    General Product Question posted February 1, 2014 by Shelby Nickell 
    Question:
    Both questions are about the model 1827EXLT, part # 96193007700 snow thrower.
    1) What is the maximum forward travel speed?
    2) What is the maximum reverse travel speed?
    The answer can be in almost any format such as MPH ot feet per minute, etc, etc.
  • Merrill Shadwell
    Did Husqvarna discontinue the snowblower models 924HV -...2
    General Product Question posted January 16, 2015 by Merrill Shadwell 
    Question:
    Did Husqvarna discontinue the snowblower models 924HV - 12527HV and 1830HV? They are no longer listed on the official Husqvarna website.

    Can someone let me know whether these models have been upgraded/replaced by newer models? And if yes what are the followup model names to look for?
  • Paul LaS
    Does anyone at Husqvarna answer product questions? Mine was...escalated
    General Product Question posted November 8, 2012 by Paul LaS 
    Question:
    Does anyone at Husqvarna answer product questions? Mine was submitted October 23 and Today is November 8. Is this site useless?
  • Gary Hoover
    Does anyone know where I can find a snow thrower attachment...Answeredescalated2
    General Product Question posted December 11, 2011 by Gary Hoover 
    Question:
    Does anyone know where I can find a snow thrower attachment for 2005 Husqvarna YTH2448 lawn tractor. The one available on Husqvarna's website and a similar looking one by AgriFab says they are not compatible with 2005 or earlier models. Thanks for your help.
  • bob mccann
    First time owner of a Husqvarna product. Last winter in the...5
    General Product Question posted January 17, 2015 by bob mccann 
    Question:
    First time owner of a Husqvarna product. Last winter in the middle of one of Chicago's worst snow storms, my old one broke down and I had to scramble to find anything to blow snow. So I found the last one in the Chicago land area. I ordered it, it was shipped and arrived in a box a few days later. I read the quick start guide, and attached all the parts and such. I was snow blowing in an hour. Great. Now its a year later and went to the garage to start up my blower. Gas tank empty, checked oil, ok.
    Looked for the fuel on/off switch? Looked for an on/off button. Looked for my paper work and could not find it. Looked for manufactures information number and such. Under a handle and some cables found a sticker. With the information on the sticker tried to find my snow blower online with the site. Bottom line, my machine has no on/off switch. My machine has no fuel on/off valve or switch. My machine has no engine throttle control. My machine is discontinued. My machine has a manual, but its in Spanish. My machine has a key switch, but the key does not turn!? My machine is not listed on the Husqvarna site. The Spanish manual has pictures of the machine, but it does not match the machine I own. The manuals offered online both on site and from manual sites, do not match my machine. The trouble shooting guide is for a machine with a key switch, a fuel valve and a throttle control. When I called and spoke to a customer service rep, she was clueless. The only help I have gotten is to take the machine into a dealer!? No manual I can read, no information online, no help with customer service rep. I feel I bought a lemon, so far its been not fun owning this machine.
  • Rod Kean
    Guys i'm just wondering if the new LED headlight can be...escalated
    General Product Question posted December 1, 2012 by Rod Kean 
    Question:
    Guys i'm just wondering if the new LED headlight can be retro fitted to the older snowblower models?