I own a Husqvarna 224L 25cc 4-Stroke Straight Shaft Gas Trimmer
the line cutter came off the bottom of my guard, does anyone have a up close photo of it are can take of there's so I will no for sure how one goes back on I just bought a new one but not sure which way it goes turned to go back on.... thanks
I have a model 128cd trimmer. After storing through winter I put in new plug and fresh fuel. Starts fine. Idles at half throttle fine. When running trimmer coughs, misses backfires and stalls out.
Please respond to jhennessey978@gmail.com
Every time it goes in for service it's expensive !
i have a 322L string trimmer i bought last year. i have taken the carb off and put it back on and now i cant get the throttle cable rerouted correctly. i need a diagram or video bad. i have looked all over the net with no luck.
Husqvarna 324L 4 stroke trimmer has 90 psi compression, won't start on starter fluid, and owner says he always has to run it on partial choke? Is this because it was set too lean? And does the low compression mean he might have scored the piston?
Used a 128LD string trimmer for the first time. When I tilted the trimmer back gas was dripping around the gas cap. I tried to re-seat the cap but still had the same issue.
I have a Husqvarna HU625HWT. I had to replace the carrier plate & mow ball assembly as they were damaged during use. String couldn't be clipped on the carrier plate b/c the clips were broken off. The mow ball assembly was cracked. I began reassembly but am confused. The locking plate spring had become rusted & stretched so I bought a new one. When removing the old parts the locking plate wasn't doing anything. The locking plate & retaining ring that I took out during disassembly & the new spring aren't currently attached because I have no idea of the right configuration for them. Not sure what they do. I believe the spring on one side attaches to the locking plate but where else does it attach? What does the locking plate do, just sit on top of the carrier plate, or? The assembly diagrams are not specific regarding connections/placement of the parts. Deeply appreciate any help or links to helpful material that can be offered.