Chainsaws

+I obtained a Husqvarna 55 Rancher without an owners manual. The data plate had the the following info: Husqvarnar 55, 967 05 29-00, 01 2600820. I went on line to find an owners manual however was unable to find one. Can anyone help?

445 18" bar chain so tight on loosest setting engine bound up

455 rancher:

Excessive oil under chain cover/bar cover.very little coming off bar when held in front of cardboard than normal.

replaced: (All From Your Service Center)
chain plate

hose from oiler to bar
hose into oiler to tank
cleaned complete chain saw
new chain
semi new bar ( about 30 cuts with it), Now New Bar.waste of
$40.00

oil makes it to hole were the bar is but from there is doesnt seem to make it into the bar, or at least not much of it.

seems from my perspective it is seeping between hose and bar or chain not taking up the bar.could it be a defective bar.

all chains and bar are from authorized center. also use lowe smoke oil, and husq. bar oil.

if you could please call me @ 813-***-xxxx / if no answer email: removed email address

now im Frustrated added new bar, and still does the same crap.

how much pressure is the oiler suppose to produce to force the oil into the bar hole.without bar running it seeps out steady.

Thanks, Brad

455Rancher AutoTune DOES NOT WORK AT ALTITUDE. This saw has not worked from Day 1. We go to around 9000' and follow all the instructions exactly, use the fancy fuel, etc., etc.,but once started (sometimes starts right away, but sometimes takes many, many tries), as soon as I touch the gas to rev it up, it dies. Every time it fails, we take it back to the dealer, which is at around 6800', and there it works fine. We have left it with them several times, and they have run a couple tankfuls of gas thru it, and tell us it is OK, but, as soon as we go out again to altitude, it does not work. Yesterday I used it at home (6800'), and it worked fine for around half an hour. I took a break, then when I resumed, it started up, but as soon as I touched the gas, it died out. Repeated about 20 times; it never did get running again. It is back in the shop now, but I have totally lost confidence in those people. Meanwhile, I'm cutting with 20-YEAR-OLD STHIL saw that has been working fine at all altitudes. Any ideas?

:( im a numpty or...

Message would only allow me to upload 1 image. When I try to add images from dropbox with a url code they don't show up so here are the other images 1 post at a time sorry... Newer chainsaw ID Plate: