My 232R brushcutter will not start as the ignition module is dead. From Husqvarna's documentation I believe the correct part number is 530 03 91-45, please can you confirm this.

Brushcutter 232R
Serial Number 5491651
Ignition module Phelon 5109A.

When I tried to get one of these modules in the UK, I found it is no longer available. Is it still possible to obtain the correct ignition module from suppliers in the USA or elsewhere in Europe?

Is there another ignition module that will work with my current flywheel to get my brush cutter running again?


On your website I found the following information:-

http://answerarmy.com/posts/05bcc2c160

If I buy a 530 03 91-43 ignition module will it work on my 232R brushcutter, as suggested in the above Answer Army Best Answer?

I might be able to get hold of a used ignition module from a 225R brushcutter, part number 503 76 16-01. The 225R brushcutter uses the same flywheel as the 232R so would this ignition module work on my 232R brush cutter?

Thanks

Chris

I purchased and received a 323R brush cutter 4/25/2013 and the 'Cutter Attachment Guard' Item 4 in the 323R Operator's manual was not in the box of parts, which will create a personal hazard when I use the brush cutter blade. Please provide the subject part, (see image of part as marked copied below). I have registered this product with Husqvarna. Up front I purchased the 323R from Amazon and as you know they don't handle replacing missing parts, even though Husqvarna benefits greatly from supplying Amazon with a lot of your products to sell. Please just send me the missing Husqvarna 323R Brush Cutter Guard, as I don't want to return your 323R back to Amazon and purchase another named brand. Also, the wing nut for attaching handle bar to the shaft is the wrong size as the holding bolt hex head does not fit it, however I will fix it. Thanks Mike Higgins 3961 Bittle Rd, Gibsonville, NC 27249 (Please note, I posted this in error in the String Trimmer area 5/1/13. As of 5/10-13/2013 I hadn't received any response):

I have the 2448 riding mower, I need to replace the drive belt for the third time in les than 9 years? The belt seams to stretch out to soon and I loose power when going up hills. so is there a belt being used that may be one inch smaller for better drive and longer use? the part recommended is
# 532 13 09-69

I have a 235r brushcutter that isn't getting spark. I'm assuming the ignition module is bad. However, the part number is obsolete (p/n 530039145). Is there another part that can be retro-fitted?
Thanks,
Winston