Zero Turn Mowers

2012 mz5424s leaving grass, especially dandelion chutes like that's its job ever since it was brand new. Dealer says everything's fine. Multiple brand new sets of blades and 3 new spindle assemblies haven't helped and I'm very unhappy but Husqvarna said that as long as there was no defect that they basically don't care. So was hoping someone could tell me something, maybe a stronger tensioner pulley spring, not sure, thanks.

4824 ez
pump tensioner spring broke and bought a new one.
obviously it attaches to the tensioner bolt located under the seat, but from there where does it attach to?

dealer parts page shows spring in exploded view only.

About 1 yr ago and 50 hrs on my 52 inch this takes place.

1. first machine had defective drive and knock in the engine.

2. front roller on mower breaks in first 2 hrs use


3. about 10 hrs. a mower pulley falls off. had to take back to dealer

3. about 15 hrs use, one blade falls off and I had to buy a 3 piece blade set according to my dealer.

4. machine stalls when mowing semi moist grass because the cuttings will not through out and clear the housing. I have to raise deck and or back up to clear machine.

5. Called dealer and said, in the first 6 mts use, the battery would not hold a charge, charging issue or bad battery. He said battery was not covered. Well, my mechanic said it is the battery for sure. So, I have to buy a new battery.

6. about 40 hrs. The muffler guard falls off the muffler.

7. I can not believe this company does not provide an email so customers can write to them and tell them of their experiences.

8. I compare this unit to my Toro which has 250 hrs. and never been to the repair center. Nothing falls off. Toro cost $8,500.00 and my Husqavarna cost $5,600.00.

9. I know this is a quality control issue plus my dealer seems to care less. Why should I have t buy a battery after just 6 mts. and I also use this unti 7 mts a yr.

I would like the company to contact me in hopes they can improve their machine.

I know there must be another way but hopefully they will get this.

Why would they not

4.

After only 2.5 mows with a brand new MZ 52, kohler 7000 series 25hp, it started sputtering and dying. After letting it sit for a while, it'll start back up and idle for as long as you want, but once you start driving or mowing, it'll do the same thing, sputter and die, after just a few minutes. You can save it by choking it sometimes, but it doesn't last. I replaced the fuel filter, thinking maybe it had some junk in it from the start, but that didn't help. Also put a new tank of gas in. Also no help. I don't wanna do anything wrenching, so as not to void the warranty. The pickle of it is, that I purchased it online, and had it shipped from 9 hrs away, because it was a great deal (or so I thought). Trying to contact someone that'll do warranty work for me here, but was wondering if there's anything else I could try in the meantime. If where I bought it were close, I'd have already been there raising heck. Very frustrating. Any advice?

All, husqvarna rz46i. Blades are always engaged. Even when I pull up and push down on electric pto, it doesn't matter...blades are engaged. At startup, if electric pto is pushed down the mower starts but it starts with blades engaged. If electric pto is pulled up, mower will not start (as it shouldn't start with pto in on position). What is going on!!??